Deep Pour Super Clear Casting Resin (6.65kg)

Deep Pour Crystal clear, UV stabilised epoxy casting resin suitable for castings and coatings up to 40mm in thickness for large areas like tables.

Resin Part A = 1kg
Hardener Part B = 330g

Recommended for large castings.

If making multi-layer coatings, the next layer can be applied after hardening of the first one. (The coating or castings must be left for +-48 hours)

How to use 
Pot life 40min

Mix Ratio = 100:33 by weight

Note: Most epoxies are classified as a hazardous material and highly toxic, it is recommended to wear a respirator when working with epoxies.
Do not work with epoxy resin if you are pregnant

Do not work in conditions below 18degrees (heating up your area is recommended)

Note: Accurate digital scale needed

Tips & Tricks

To minimize bubbles in resin:

1. **Mix Slowly:** Stir the resin slowly to avoid introducing air. Stir for at least 2 minutes, scraping the sides and bottom.

2. **Use a Torch or Heat Gun:** Pass a torch or heat gun over the surface to burst bubbles. Do this shortly after pouring, but be cautious not to scorch the resin.

3. **Warm Resin and Molds:** Warm the resin and molds before pouring to reduce viscosity and help bubbles rise and pop more easily.

4. **Pour in Thin Layers:** Pour resin in thin layers to allow trapped air to escape more effectively.

5. **De-gas if Possible:** If using a vacuum chamber, degas the resin before pouring to remove air bubbles.

6. **Avoid Over mixing:** Over mixing can introduce more air. Mix only as much as needed.

Remember to follow the specific instructions for the resin you're using.