Clear Casting UV Stable Epoxy Resin 1:1 ratio

Crystal Epoxy Casting Resin, UV stabilized epoxy casting resin suitable for castings and coatings up to 10mm in thickness for large areas, for small items the thickness can be higher.

- Low Odour
- Non Yellowing
- Food Safe

1:1 mix ratio by volume 

100:90 by weight 
Resin Part A = 5kg
Hardener Part B = 4.5kg

Recommended for jewellery casting, 3D resin art, encapsulation, paintings, table tops and more.

If making multi-layer coatings, the next layer can be applied after hardening of the first one. (The coating or castings must be left for +-24 hours)

How to use
Pot life 40min
24 hour cure time
You can pour up to 1cm max

Mix Ratio = 1:1 by volume

Note: Most epoxies are classified as a hazardous material and highly toxic, it is recommended to wear a respirator when working with epoxies.

Do not work with epoxy resin if you are pregnant

Do not work in conditions below 18degrees (heating up your area is recommended)

Tips & Tricks

To minimize bubbles in resin:

1. **Mix Slowly:** Stir the resin slowly to avoid introducing air. Stir for at least 2 minutes, scraping the sides and bottom.

2. **Use a Torch or Heat Gun:** Pass a torch or heat gun over the surface to burst bubbles. Do this shortly after pouring, but be cautious not to scorch the resin.

3. **Warm Resin and Molds:** Warm the resin and molds before pouring to reduce viscosity and help bubbles rise and pop more easily.

4. **Pour in Thin Layers:** Pour resin in thin layers to allow trapped air to escape more effectively.

5. **De-gas if Possible:** If using a vacuum chamber, degas the resin before pouring to remove air bubbles.

6. **Avoid Overmixing:** Overmixing can introduce more air. Mix only as much as needed.

Remember to follow the specific instructions for the resin you're using.